Summary:
Suction Feed Airless High Pressure Spray guns are the preferred spray guns today. They are great for spraying just about anything including paint, va
Suction Feed Airless High Pressure Spray guns are the preferred spray guns today. They are great for spraying just about anything including paint, varnish, sealants, molds and many other products. One of the reasons why they are so popular is that you do not have to add water to increase the spray width or mess with hoses and pumps. All it takes is just one press of a button to spritz the product you are spraying! This is extremely important because if you do not press the button at the right time then there is no water or pressurized spray that could result in an overflow and an inconvenient overflow of your air conditioner.
Another reason why you want to use a Suction Feed Airless High Pressure Spray Gun is because the gun is extremely fast. It can spray a long distance in just a few seconds. This means that if you are working on a project and need to get the job done quickly, you will want to consider using a high pressure spray gun. This is especially true if you are working on a building site because if the weather is bad then you may need to get the air consumption to be up to speed as well.
There is also no need for messy hose attachments and other messy parts. Suction Feed Airless High Pressure Spray Gun has a special "O-ring" clip that allows you to tighten and loosen the nozzle easily. This is very helpful because if the screw allows it to come out, then it can damage the hose. You do not want to have any problems with your spray gun in this regard because if you damage the hose then you will have to either make another purchase or repair the gun.
The internal workings of a Suction Feed Airless High Pressure Spray Gun are very simple. The first part is the tank that holds the air. When you press the trigger, this shoots out the air into the canister and pushes the air into the tip of the nozzle. The amount of air is controlled by the "psi" that is adjusted depending on the size of the nozzle. The pressure of the air is exerted on the wood or plastic by the pressure of the air that is forced through the nozzle.
To work properly, you must keep the nozzle in an open and straight position. You will find that when you shoot the gun and the pressure is released that the spray moves up and down in a fine spray pattern. The spray is not sprayed in one continuous stream but breaks into smaller streams. These streams can be used to apply paint to the material you are working on. It is not advisable to use high pressure to clean small items such as screw heads.
Suction Feed Airless High Pressure Spray Guns requires that you use a can of compressed air to operate the gun and to keep the air in the canister at a constant pressure. There is no need to pressurize the air because you are shooting the gun with a very low pressured stream. This type of gun usually does not require you to cock the gun after each shot. The compressed air is shot out the top of the barrel at high pressure and the stream of the air is expelled in a fine spray pattern.
Suction Feed guns are excellent for spraying a wide range of different materials with very little maintenance required. These types of guns come in two forms, the direct vent and the rotary vane. A small hole in the bottom of the gun allows the compressed air to be sucked into the canister to be shot out the other end. Rotary vane guns use a crank mechanism to cause the spray to rotate around an axis. These guns have a limited shelf life but you will not need to clean them like the compressed air guns because there is no chamber to clean.
The cost of these guns is dependent on the type of gun and the size of the nozzle and the air pressure. Most guns that are powered by electricity run on a small charge while guns using compressed air have to be recharged regularly. If you want a long lasting gun, then it is best to go for the electric powered gun. The price of these guns varies depending on the material they are being used for and the features they come with. High pressure guns tend to require more maintenance than other guns.
China Pneumatic Tools Manufacturers
0086-574-88160200
Chating Village, Yinzhou District, Ningbo, Zhejaing China.